Motor-driven expansion board L298P motor control shield For Arduino

L298P Motor Driver Shield - H-bridge Drive Shield Expansion Board High-Power DC or Stepper Motor Controller For Arduino

-Adopt dedicated high-power motor driver chip L298P which can directly drive two DC motors with drive current up to 2A

-Use eight high-speed Schottky diodes at motor output as protection

-Stack design can be directly plugged into the Arduino, easier to use

-The L298P shield DC motor driver has PWM speed control mode

Technical Specifications:

logical part of the input voltage VD: 5V

driven part of the input voltage VS: VIN Input 6.5 ~ 12V, PWRIN 4.8 ~ 35V input

logical part of the work current Iss: Less than 36mA

driven part of the operating current Io: Less than 2A

maximum power dissipation: 25W (T = 75 Celsius)

control signal input level: High 2.3V low -0.3V

Working temperature: -25 + 130 Celsius

hardware interface: 5.0mm pitch terminal

belt clip and can be controlled via front row access signal

Drive Type: Dual power H-bridge driver

Pin occupancy: D4 ~ D7 direct drive motor

supports PWM / PLL mode motor speed control

Size: 68 * 53mm

For More Details on PC Click here

For More Details on Portables Click here.